RCC Drawing MCQ Questions with Answer
RCC drawing is a Reinforced Cement Concrete Drawing or also common, just RC (Reinforced Concrete) drawing. It shows the layout of steel reinforcing bars in the concrete and sometimes the schedules for cutting and bending the bars.
In this PDF You will find the list 250 MCQ Question With Answers of RCC Drawing. You can easily download this PDF of RCC Drawing MCQ Questions in high resolution and printable format using given link below.
RCC Drawing MCQ Question With Answers
An R.C.C. beam of 6 m span is 30 cm wide and has a lever arm of 55 cm. If it carries a U.D.L. of 12 t per m and allowable shear stress is 5 kg/cm2, the beam
A. Is safe in shear
B. Is safe with stirrups
C. Is safe with stirrups and inclined bars
D. Needs revision of section
According to I.S. : 456, slabs which span in two directions with corners held down, are assumed to be divided in each direction into middle strips and edge strips such that the width of the middle strip, is
A. Half of the width of the slab
B. Two -third of the width of the slab
C. Three-fourth of the width of the slab
D. Four-fifth of the width of the slab
The load stress of a section can be reduced by
A. Decreasing the lever arm
B. Increasing the total perimeter of bars
C. Replacing larger bars by greater number of small bars
D. Replacing smaller bars by greater number of greater bars
The column head support a flat slab, is generally kept The diameter of
A. 0.25 times the span length
B. 0.25 times the diameter of the column
C. 4.0 cm larger than the diameter of the column
D. 5.0 cm larger than the diameter of the column
Fixed at its ends, the If is the uniformly distributed load on a circular slab of radius maximum positive radial moment at its centre, is
A. 3WR²/16
B. 2WR²/16
C. WR²/16
D. None of these
The maximum ratio of span to depth of a slab simply supported and spanning in one direction, is
A. 35
B. 25
C. 30
D. 20
If the width of the foundation for two equal columns is restricted, the shape of the footing generally adopted, is
A. Square
B. Rectangular
C. Trapezoidal
D. Triangular
The floor slab of a building is supported on reinforced cement floor beams. The ratio of the end and intermediate spans is kept
A. 0.7
B. 0.8
C. 0.9
D. 0.6
Pick up the correct statement from the following:
A. Lateral reinforcement in R.C.C. columns is provided to prevent the longitudinal reinforcement from buckling
B. Lateral reinforcement prevents the shearing of concrete on diagonal plane
C. Lateral reinforcement stops breaking away of concrete cover, due to buckling
D. All the above
In case the factor of safety against sliding is less than 1.5, a portion of slab is constructed downwards at the end of the heel slab, which is known as
A. A key
B. A cut-off wall
C. A rib
D. All the above
RCC Drawing MCQ Questions with Answer PDF can be downloaded from the link given below.
